Table of Contents

1. Challenge

   Using YaST, Add the Two Time Servers: `tick.jrc.us` and `tock.jrc.us`

   1. Launch the YaST ncurses interface:

      sudo yast
      

   2. On the left select Network Services.

   3. On the right select NTP Configuration.

   4. Configure Start NTP daemon to Now and on Boot.

   5. Tab to Configuration Source, select Dynamic, and arrow down to change it to Static.

   6. Tab down to Servers and select Add.

   7. Replace the existing server with tick.jrc.us, select Test to ensure it is responding, and then go to OK.

   8. Tab down to Add, add tock.jrc.us, and select Test to make sure it is reachable.

   9. Tab to Quit at the bottom of the page, until you have exited YaST completely.

2. Challenge

   On the Command Line, Use `chronyc` to Verify the Time Servers Are Set and Responding

   1. At the shell prompt, run the command:

      chronyc sources -v
      

      You will see there is a third time server configured. This server is provided as a reference. Look at the output of the server at the 169 address and compare the output of tick and tock to ensure they are workking.

   2. Run the command again, and check to ensure the RX count has increased and the servers are running.